So, while we’re on the Knit Block detour we might as well finish this conversation.
As you know, I’ve been using my adjusted Burdastyle 2012-09-123 T-shirt as my tentative Knit Block. And it’s been working OK. No major complaint apart from the sway-back type puddle in the lower back. So I thought I’d try designing with it. Nothing fancy, just a simple U-neck T.
I was going to make it with 3/4 sleeves. But the fabric I had in mind was a $1/yard remanent from FIDM’s Scholarship Store in LA, so not enough for long sleeve. No problem I thought. I’ll just make a short sleeve version.
Straightforward right? Sadly no.
See those pulls emanating from the neckline towards the shoulder? I had no such problem with the previous makes based on this Knit Block. It could be the fabric, though this one seem just as stretchy. My bet though is on the short sleeve. All my previous makes were long sleeves. I think maybe the weight of the long sleeves pulled the shoulder seams in place. So I hadn’t really noticed that the shoulders were really too short.
Here’s how it compare with my zero-ease Moulage pattern:
Apology for the confusing extra lines – they’re for the blouse/dress, jacket, & coat slopers. I’m waiting to test them out with muslins before separating them into heavy paper Blocks. The heavier red lines show the Moulage.
The shoulder is about 3/8″ too short. Waist is zero ease, and Bust & Hip are both currently negative ease (even accounting for the bit taken out by the Moulage darts).
I think I need to redo the Knit Block, get back to basic principles. Specifically, where it’s OK to have negative ease and where it should be kept at zero ease. And maybe figure out a totally zero-ease Knit Block for those less stretchy knit fabrics.
And I thought I was saving time by starting with a commercial pattern for knit! Sometimes there’s no substitute for learning properly, especially if one intend to get creative with pattern making.